It looks like their filament was too wet when they printed it, or they haven’t calibrated the extruder properly. But wet filament is the usual culprit for stringy prints.
Because it’s a Photoshop job of an actual Jesus Nut. There’s a wiki link in the thread and the page has this exact picture, mirrored and with no edits.
Of course it’s a joke, but I am genuinely curious about why the 3d printed part looks so shitty.
It just looks like it’s been painted in anti seize paste.
But I think it’s just a really bad print.
That’s what I thought it was before I read the caption
Both photos are edits of the pictures on the wiki for “jesus nut”
15-20 years ago this is what we considered to be a good 3D print.
It looks like they 3D scanned it, and printed it rust and all.
It looks like their filament was too wet when they printed it, or they haven’t calibrated the extruder properly. But wet filament is the usual culprit for stringy prints.
Because it’s a Photoshop job of an actual Jesus Nut. There’s a wiki link in the thread and the page has this exact picture, mirrored and with no edits.
Looks like it’s been sand blasted